We are unique in the market thanks to a patented proprietary build system: P201531521
The parts are designed by our engineers and cut with laser technology. We take maximum care of the finish of the structure offering two types of structure.
Galvanized
Durable protection of the structure is obtained thanks to the treatment by immersion in zinc at 450ºC. Protects the structure from oxidation and corrosion.
Painting
We apply two coats of primer in the factory and one of synthetic enamel on site. This gives it extra quick drying, toughness, elasticity and adhesion to the structure of the ship.
The adjustment of the facade panels with those of the roof is millimetric
Our false ceilings offer a continuous ceiling without cuts or recesses, hiding the beams and the installations inside. They considerably increase thermal insulation and favors the effectiveness of ventilation systems.
TYPES OF FALSE ROOF IN A POULTRY HOUSE
Panel cover with high density polyurethane insulation and two lacquered sheets, with 20-25% pending, screwed on belts with die-cut ridge and tip-panel finish. Thus, the deterioration of the polyurethane is avoided, both by atmospheric agents and by pests.
The thickness of the roof is decided by the client and usually ranges from 30mm to 60mm.
We ensure the safety and tightness of our buildings
We seal the joint between the corners of the facade and the false ceiling, installing a sanitary profile made of PVC. It is a PVC strip that adapts to the surface of the panels thanks to its flexible lips and seals them, facilitating cleaning and preventing dirt from nesting in the corners, increasing the hygiene of the premises.
This profile makes it possible to round off the meetings of the plates of the different faces, eliminating the right angles of 90º.
Skirt made with pre-lacquered sheet metal or sandwich panel and galvanized tube that is screwed to the structure. It is installed in areas of the building where there are ventilation or cooling hatches for protection, in order to control air intakes avoiding negative influences from the wind.
Manufactured with 80mm aluminum profile, with thermal break, triple rubber seal and sandwich panel. Total tightness and maximum insulation.
FOR FAN
We use supports with lifting motors and fasteners for feed line pulleys, supports and hoppers. Made of stainless steel sheet, laser cut and folded to size, they are fastened to the straps by stainless steel nuts..
We equip doors and covers with a plank of stainless steel protection and rubber seal, avoiding the entry of air through the lower part of the doors. With this, inside the house, on the ground, a bed of sawdust is laid so that the birds are comfortable and the plank helps to prevent the sawdust from getting out when the door is opened.
Thanks to the plank, the passage through the door is flat and does not disturb
Cooling is a ventilation system that allows air to pass through in optimal conditions.
At Agrometal we lengthen the beams so that the roof is longer in the area that the cooling will occupy, leaving the cabin semi-closed. In this way, the cooling system forces the air to enter through a specific area and in the best conditions.
HABLEMOS SOBRE TU PROYECTO
Dirección
C/ Diseminados s/nº
Polígono 4 Parcela 259, 02270 Villamalea, Albacete (Spain)
Teléfono
+34 967 48 31 95
Escríbenos